four wheels drive wheel loader
Model No. : ZL08
four wheels drive wheel loader Description:
Wheel Loader Safety Precautions for Use
the safety precautions of the engine starts and during operation
①Make sure there is enough oil for the diesel engine.
② Clear the barrier on the road where the wheel loader will walk, with particular attention to iron, like ditches of obstructions so as not to cut tires.
③l Adjust the rear-view mirror enough so that the driver after seating can have the best vision effects.
④ Ensure that the speakers ,the back lights and all of the safety devices of the wheel loaders work properly.
⑤ Before you will start the engine at once or check if the turning around is flexible in place, Please press the horn to warn those around them to pay attention to safety.
⑥ Before starting the wheel loader, you should try all of the manipulation handles, pedals, steering wheels to make sure that all of them in a normal state. Then you can begin to enter the job. You should pay special attention to check if the steering, braking is good. Determine the steering, brakes completely work normally before they start to run.
⑦ When you drive the wheel loader, please place the bucket away from the ground about 400mm high. When you drive the wheel loaders on the mountains or across ditches and other obstacles, please slow down and turn small corner to avoid tipping. When the load side begins to slide into the side of the slopes, you must unload the articles from the wheel loader immediately to prevent further slipping.
⑧ During operation to avoid tires excessive over-skid; try to avoid two tires vacant, not allow to continue to work when only 2 wheels are touching the ground.
⑨ For tractor, only allowed to hook up with the traction device has been between the traction material and wheel loaders are not allowed to stand on, and to maintain a certain safe distance to prevent security incidents.
1.0 Engine details:
(1) Model: Changong CG25
(2) Engine type: Direct-injection, water-cooled, one-cycle diesel Engine
(3) Rated Power: 17.27KW
(4) Rated Speed: 2200 r/min (rpm)
(5) Fuel Consumption ratio in standard working condition: 244.8g/kw.h
2.0 Steering System
(1) Cycloid full hydraulic steering system: BZZ-200
(2) System Pressure: 16MPa
3.0 Bucket
(1) Bucket Capacity: 0.4 m3
(2) Bucket width: 1300mm
(3) Max. Breakout Force: 13KN
(5) Rated Load: 800kg
(6) Operating Weight: 2350kg
4.0 Overall Dimensions
(1) Overall Length (Bucket on ground position): 4260mm
(2) Overall Height
(a) Ground to Cab Top: 2350mm
(b) Ground to exhaust pipe: It is below from the top of cabin
(3) Overall Width: 1550mm
5.0 Operating Specifications
(1) Drive Means: Four-wheel drive
(2) Min Turning Radius: 4000mm
(3) Driving System: mechanical
(4) Dumping Height: 2700mm
(5) Dumping Reach at max height: 700mm
(6) Min the ground distance: 300mm
(7) Time of raise: 7 sec.(full load)
(8) Hydraulic cycle time: 12.5sec.
6.0 Brake System
(1) Service Brake: Four Wheel Hydraulic spread-shoed brake
7.0 Tyre
(1) Model: 8.25-16 (2) Width: 20cm (3) Diameter: 80cm
8.0 Wheelbase: 1950mm
9.0. Track: 1320mm
